Installing The Security Lock Option; Battery Pack Installation - Texas Instruments Extensa 60x Series Maintenance Manual

2.5.5

Installing the Security Lock Option

Use the following procedure to install the optional Kensington
1. Unpack the Kensington Lock Kit.
2.
Secure the loop end of the lock to a permanent fixture located such that
the notebook can be installed in a desired location.
3.
Insert the lock into the slot on the left side of the computer.
4. Rotate the key to its locked position and remove the key.
This completes the options installation subsection.

2.6 Battery Pack Installation

1.
Turn off the computer and disconnect the AC adapter if attached to the
computer.
2.
Unlatch the battery compartment door (right front corner of the unit) as
shown in Figure 2-3.
3.
Slide the battery compartment door out slightly and then swing the door
outward as shown in Figure 2-3.
4.
If changing batteries, grasp the loop attached to the battery and pull the
battery out of the compartment.
5. Look for label "THIS SIDE UP" and insert the battery with label up until it
snaps in place; then close the battery compartment door.
2-10 Installation
Figure 2-3 Battery Pack Installation
®
security lock.