Teledyne 356WA Instruction Manual page 27

T T T T T race Oxyg race Oxyg race Oxygen Anal race Oxyg en Anal en Anal en Analyz
race Oxyg en Anal
NOTE: If electrolyte has severely etched the
column, it should be replaced.
i) After the reservoir and column
1) Grasp the tube, and with a
2) Angle the bottom of the tube
3) The top and bottom O-rings will
1) Engage the top of the tube in the
2) Swing the tube into line, and
The flowmeter is similarly constructed
NOTE: NOTE: NOTE:
NOTE: NOTE:
and can be removed and reinstalled
following the same procedure outlined
above.
Refer to the Spare Parts List in the Appen-
dix for replacement part numbers for the
yz yz yz yzer er er er er Maintenance & Maintenance & Maintenance & T T T T T r r r r r oub
Maintenance & Maintenance &
Figure 5-2. After cleaning,
thoroughly rinse the column in
distilled water before
reinstalling.
have been cleaned, refill the
reservoir as outlined in Section
4.1: Filling the Reservoir .
Removing the Humidifier Removing the Humidifier Removing the Humidifier Removing the Humidifier Removing the Humidifier
Column: Column: Column:
Column: Column:
twisting motion, work it up into
the top humidifier block until it
clears the bottom block
completely.
towards you and twist it free of
the top block.
remain captive in their blocks.
To Reinstall: To Reinstall: To Reinstall:
To Reinstall: To Reinstall:
top block at an angle and twist
up into the cavity of the top
block unit the bottom of the tube
clears the bottom block.
twist down into the bottom
block until the tube seats.
Teledyne Analytical Instruments
oubleshooting 5 oub oub leshooting 5 leshooting 5 leshooting 5
oub leshooting 5
Figure 5-2: Removing/Replacing the
Humidifier
5-5