Related Manuals for SWR BASS 350
Summary of Contents for SWR BASS 350
- Page 1 BASS 350 USER GUIDE 8860 E. Chaparral Rd. Suite 100 Scottsdale, AZ 85250-2618 USA PHONE: (480) 596-9690 FAX: (480) 367-5262 EMAIL: custserve@fenderusa.com WEB: swrsound.com © 2001 SWR...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS CAUTION: TO REDUCE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER OR BACK. NO USER-SERVICEABLE PARTS INSIDE. PLEASE REFER TO A QUALIFIED SERVICE TECHNICIAN. A. Read Instructions: All safety and operation instructions should be read before the product is operated. B. - Page 3 The Bass 350 maintains the same quality components and materials found in all SWR products and is assembled by hand at our factory in California. The two preamp gain stages utilize a specially-selected Groove Tubes 12AX7A.
- Page 4 SWR BASS 350 — SPECIFICATIONS Note: All measurements were taken with a line voltage of 120VAC. All noise specifications are “unweighted.” All voltages and watts are “RMS.” All measurements were taken with tone controls set flat, Aural Enhancer at minimum.
-
Page 5: Gain Control
2 o’clock. This position of the Enhancer brings out both the low end fundamentals and crisp highs and, at the same time, adds a little lower midrange to help cut through the band. BASS 350 USER GUIDE... - Page 6 AND get the diversity an effects unit offers. This circuit is also effective in reducing noise generated by effects units because it is located after the gain stages in the preamp. BASS 350 USER GUIDE...
- Page 7 When the threshold (starting point) of the Limiter Circuit is reached, the Limiter Active LED will light, indicating that the Limiter Circuit is active. The Limiter LED will be inactive when the Limiter is defeated or when playing at lower levels. BASS 350 USER GUIDE...
-
Page 8: Rear Panel Features
Use of the effects loop should greatly reduce the noise generated by effects units (as compared to using the effect between your instrument and the input jack). This is because the loop is after the preamp gain stages. BASS 350 USER GUIDE... - Page 9 Effects Send Jack is 100 ohms. This jack can be used as a line level output for use in conjunction with a slave power amp such as SWR’s Power 750. It may also be used as an unbalanced record out.
-
Page 10: Suggested Settings
Recommended SWR Speaker combinations for use with the Bass 350 include: • (2) Goliath IIIs • (2) Goliath Junior IIIs (8 ohm version) • (2) Son Of Berthas • (1) Goliath Junior III & (1) Son Of Bertha • (1) Goliath Junior III & (1) Big Ben •... - Page 11 SWR BASS 350 — SUGGESTED SETTINGS Midrange Aural Enhancer Bass Level Frequency Treble ROCK Midrange Aural Enhancer Bass Level Frequency Treble REGGAE Midrange Aural Enhancer Bass Level Frequency Treble JAZZ Midrange Aural Enhancer Bass Level Frequency Treble SLAP Midrange Aural...
- Page 12 Authorized SWR Dealer. This warranty applies only to products purchased in the USA or Canada. This warranty is VOID if the unit has been damaged due to accident, improper handling, installation or operation, shipping damage, abuse or misuse, unauthorized repair or attempted repair, or if the serial number has been defaced or removed.