IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS WARNING – WARNING – TO REDUCE THE RISK OF TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT OF A FIRE, ELECTRIC SHOCK OR INJURY TO PERSONS, RANGE TOP GREASE FIRE, OBSERVE THE OBSERVE THE FOLLOWING: FOLLOWING*: A.
www.GEAppliances.ca SAFETY PRECAUTIONS WARNING – D. Ducted fans must always be vented to the TO REDUCE THE RISK OF outdoors. A RANGE TOP GREASE FIRE: WARNING – A. Never leave surface units unattended at TO REDUCE THE RISK OF high settings. Boilovers cause smoking and FIRE, USE ONLY METAL DUCTWORK.
Using the hood controls. Throughout this manual, features and appearance may vary from your model. A - MOTORSTOP H - LED TIMED INTENSIVE SPEED B - SPEED DECREASE I - “ON-OFF’ LIGHT - MOTOR OPERATING PERFORMANCE CHECK- D - LED:SPEED 1 UP.
Care and cleaning of the vent hood. www.GEAppliances.ca Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the vent hood. Make sure lamps are cold before cleaning the hood. To clean the filter/s We recommend you wash the filters at least once a month, by hand or in the dishwasher.
Page 6
Care and cleaning of the vent hood. Be sure electrical power is off and all surfaces are cool before cleaning or servicing any part of the vent hood. Replacement of lamps (Models PVWS930, PVWS936, PVWT936, PVWG936, PVIG940) Unscrew the lamp diffusers. Remove the blown lamp and replace it with a new 20 Watt (max) 12 Volt halogen lamp with a G-4 cap.
Installation Range Hood Instructions Questions? Call 1-800-561-3344 GEAppliances.ca or Visit our Website at: www. CAUTION BEFORE YOU BEGIN Due to the weight and size of these vent hoods and to Read these instructions completely and carefully. reduce the risk of personal injury or damage to the IMPORTANT –...
24 ft. *Actual length of straight duct plus duct fitting equivalent. Equivalent length of duct pieces are based on actual tests conducted by GE Evaluation Engineering and reflect requirements for good 1 Ft = 0.3 m venting performance with any ventilation hood.
Page 10
Installation Instructions TOOLS AND MATERIALS REQUIRED OPTIONAL ACCESSORIES (NOT SUPPLIED) Kit 02279 Model PVIG940 MAX 48.4” extension chimney (H) MIN 34.8” Kit 02280 Model PVWG936 MAX 52” extension chimney (H) MIN 36.4” Kit 02281 Models PVWS930/936 extension chimney (H) MAX 52” MIN 36.4”...
Page 11
Installation Instructions PARTS PROVIDED - DUCTING OPTIONS AND EXAMPLES Continued MODEL PVWG936 Closely follow the instructions set out in this manual. All responsibility, for any eventual inconveniences, • Hood canopy with internal blower, grease filters and damages or fires caused by not complying with the lights already installed instructions in this manual, is declined.
Page 12
Installation Instructions 9. Models PVWS930/936 and PVWT936: WALL INSTALLATION Attach the 2 hooks with leveling screws (provided in the FOR MODELS PVWS930, PVWS936, PVWT936 AND assembly kit) to the points marked on the template with PVWG936 ONLY 2 screws and then remove the template. Model PVWG936: (For model PVIG940 installation, please refer to the Screw 2 screws on lower fixing point but do not tighten...
Page 13
Installation Instructions WALL INSTALLATION - Continued Ø 3.5 x 9.5 13. Model PVWG936: Fix the 2 supplied brackets on the rear side of the motor housing with 4 screws each. Models PVWS930/936 and PVWT936 Lower Support Bracket Ø 3.5 x 9.5 Ø...
Page 14
Installation Instructions WALL INSTALLATION - Continued Models PVWS930/936 and PVWT936 Duct Cover For models PVWS930/936 recirculation grids must be mounted on the laterals of Duct Cover. Ø 3.5 x 9.5 Run 3 wires; black, white and green, according to the National Electrical Code and local codes and ordinances, in ½"...
Page 15
Installation Instructions Note the position of the front part of the hood and CEILING INSTALLATION proceed with the installation. FOR MODEL PVIG940 ONLY Note: All fastener location must span the studs otherwise proceed as described in Step 4. (For models PVWS930/936, PVWT936 and PVWG936 installation, please refer to paragraph "WALL 4.
Page 16
Installation Instructions CEILING INSTALLATION - Continued 14. Install the glass vapour catcher with 4 screws and bushes, place the rubber tape between the canopy metal edge and the glass (see drawing ) Ø 6 x 80 Ø 3.5 x 9.5 11.
Before you call for service… Troubleshooting Tips Save time and money! Review the charts on the following pages rst and you may not need to call for service. P r o b l e m P o s s i b l e Causes What To Do Fan does not operate A fuse may be blown or a...
Page 19
Please place in envelope and mail to: Veuillez mettre dans une enveloppe et envoyez à : OWNERSHIP REGISTRATION P.O. BOX 1780 MISSISSAUGA, ONTARIO L4Y 4G1 (FOR CANADIAN CONSUMERS ONLY - POUR RÉSIDENTS CANADIENS SEULEMENT)
Page 20
OWNERSHIP REGISTRATION CERTIFICATE – FICHE D’INSCRIPTION DU PROPRIÉTAIRE Please register your product to enable us to contact you in Veuillez enregistrer votre produit afin de nous permettre de the remote event a safety notice is issued for this product communiquer avec vous si jamais un avis de sécurité concernant and to allow for efficient communication under the terms of ce produit était émis et de communiquer facilement avec vous en our warranty, should the need arise.
Range Hood Warranty. All warranty service provided by our Factory Service Centers, or Staple your receipt here. an authorized Customer Care ® technician. To schedule service, Proof of the original purchase on-line, 24 hours a day, visit us at www.GEAppliances.ca, or call date is needed to obtain service 1.800.561.3344.
GE Appliances Website GEAppliances.ca Have a question or need assistance with your appliance? Try the GE Appliances Website 24 hours a day, any day of the year! For greater convenience and faster service, you can now download Owner’s Manuals, order parts or even schedule service on-line.