Formatting The Phu-60K/120K/120R; Checking The Remaining Time Available For Recording; Restoring The Phu-60K/120K/120R - Sony PMW-F3K Supplement Manual

Subsequently, the access lamp of the
camcorder lights in red then changes to green
once the unit is ready for use.
Notes
• The cover of the card slot block cannot be
closed with the PHU-60K/120K/120R
connected.
• Bundle the cable so that it will not accidentally
get on nearby objects.
To disconnect the PHU connection cable
Operate in the same manner as when you remove
an SxS memory card from the slot.
Formatting the PHU-60K/120K/
120R
For a PHU-60K/120K/120R that is not formatted
or that was formatted with another system, the
message "Unsupported File System" is displayed
on the LCD monitor/viewfinder screen.
Format the PHU-60K/120K/120R as instructed
below.
To execute formatting
Using "Format Media" of the OTHERS
menu, specify "Media(A)" (slot A) or
"Media(B)" (slot B) then select "Execute."
Formatting begins.
An in-progress message and status bar (%) are
displayed, and the access lamp lights in red.
When formatting is completed, a completion
message is displayed for three seconds.
Notes
• Formatting for the PHU-60K/120K/120R on
this camcorder is "Quick Format" with which
only the managerial data are erased. To erase
the recording data completely, connect the unit
to a PC and perform "Full Format."
• The PHU-60K/120K/120R to be used with this
camcorder must be formatted using the format
function of this camcorder. Any PHU-60K/
120K/120R formatted with another device must
be formatted again with this camcorder.
4 Using an External Hard Disk
Checking the Remaining Time
Available for Recording
In E-E Display/Recording mode, the remaining
capacity (in minutes) of the PHU-60K/120K/
120R connected via a card slot is displayed on the
LCD monitor/viewfinder screen.
120min STBY
A: 185 min
B: - - - min
Z99
The available time for recording with the current
video format (recording bit rate) is calculated
according to the remaining space of the hard disk
and displayed in time units of minutes.
The remaining capacity can also be checked in a
meter format on the BATTERY/MEDIA status
screen.
Restoring the PHU-60K/120K/
120R
If an error occurs with data on the PHU-60K/
120K/120R for some reason, the hard disk must
be restored.
If a PHU-60K/120K/120R that needs to be
restored is connected, a message that prompts you
to execute restoration is displayed on the LCD
monitor/viewfinder screen.
To restore the hard disk
Select "Execute" by turning the jog dial
then push the dial.
Restoration begins.
During restoration, an in-progress message and
status bar (%) are displayed, and the access lamp
is lit in red.
When restoration is completed, a completion
message is displayed for three seconds.
If restoration fails
• A PHU-60K/120K/120R on which an error
occurred may become usable again through
reformatting.
• In some cases, only parts of clips cannot be
restored. Playback of the restored clips becomes
possible again.
STBY T