Epson Endeavor User Manual page 191

Mass storage, Intro-l, Intro-3, A-4
Master drive, 3-4
Math coprocessor, Intro-l, 2-1,
2-23, 4-7, 4-9, A-2
Memory,
adding, Intro-2, 2-l, 2-11—16
configuration, Intro-2, 2-11, 2-14,
2-16, A-l
diagnostics, 4-1, 4-7, 4-9, 6-56—25
error messages, 4-9,6-5
extended, A-8
map, A-8
modules, see SIMMs
problems, 6-25
SETUP, 2-14, 2-16, 2-25, 6-25
shadow RAM, Intro-l, A-2
SIMMS, see SIMMS
specifications, A-l-2, A-8
tests, 41, 4-7,4-9
video, Intro-2, 2-24—26, A-2
Microprocessor, Intro-l, 2-1,2-3,
2-6-8, 2-23, A-l-2
Microprocessor socket, 2-23
MODE command, 6-23
Modem, 2-l
Module(s), memory, see SIMMs
Monitor,
CGA, 2-7
diagnostics, 6-13-14
error messages, 6-5
interface, A-3
jumper settings, 2-7, 2-28, 6-9, 6-14,
6-23
port, A-3
problems, 6-5, 6-13-14
Mounting frames,
attaching, 3-19
removing, 3-6—7
6 Index
Mounting plate, hard disk, 3-9-11,
3-16
Mouse,
driver, 6-24
interface, Intro-l, A-3
port, Intro-l, A-3
problems, 6-24
MS-DOS,
batch files, 1-27
copying files, 1-9
error messages, 6-16
hard disk drive, 6-19—20
printer commands, 6-22
single diskette drive system, l-16
stopping commands, l-21, 6-8, 6-21
version number, 6-1
N
Noise, acoustical, A-6
Non-destructive surface analysis,
5-2—3, 5-10—11
Non-IDE hard disk drive, 3-36, 6-19
Numeric coprocessor, Intro-l, 2-1,
2-23, 4-7, 4-9, A-2
Num lock mode, l-20—21, 6-12, A-3
0.
Operating speed, see
Processor speed
Operating system, l-3—41, -16-18,
l-22, 1-25-27, 3-4, 3-36, 5-1, 6-1,
6-19—20
Optional equipment, Intro-2,
2-l—30
Option card connector board,
locating, 2-3, 3-33
removing, 2-21
replacing, 2-22, 3-35