Epson Endeavor User Manual page 143

If you are runnin g an application program, see if you need
6.
to set up the program for the type of monitor and display
adapter you have. Also make sure you are using the
appropriate monitor and display adapter for your software.
Note
If your application program requires a monitor that
supports graphics but you have a monochrome monitor,
the results will be unpredictable.
If you installed a display adapter card (and did not connect it
7.
to the feature connector on the main system board), you
must set jumper J6 to disable the built-in VGA adapter or
you will not see anything on the screen. See "Changing the
Jumper Settings" in Chapter 2 for instructions.
If you still have difficulty with your monitor, run the Video
8.
adapter diagnostic tests described in Chapter 4. If the
diagnostics program indicates an error, contact the
representative who sold you the monitor.
6-14 Troubleshooting
J