Su P E R Vi S Or P A S S Wor - SOYO 5EAS5 User's Manual & Technical Reference

P54c/p55c pci mainboard
Table of Contents

Advertisement

34
Parallel Port Mode
ECP Mode Use DMA
Parallel Port EPP Type
Supervisor Password
Based on the setting you made in the ÒSecurity OptionÓ of the ÒBIOS
FEATURES SETUPÓ, this Main Menu item lets you configure the
system so that a password is required every time the system boots or an
attempt is made to enter the Setup program. Change the password as
follows:
1. Choose ÒSUPERVISOR PASSWORDÓ in the Main Menu and press
<Enter>. The following message appears:
2.
Enter a password and press <Enter>.
(If you do not wish to use the password function, you can just press
<Enter> and a ÒPassword disabledÓ message appears. )
3. After you enter your password, the following message appears
prompting you to confirm the new password:
4. Re-enter your password and then Press <ESC> to exit to the Main
Menu.
Important: If you forget or lose the password, the only way to access
the system is to set jumper JP5 to clear the CMOS RAM.
All setup information is lost and you must run the BIOS
setup program again.
Choose ECP + EPP (default), Normal
or EPP, ECP mode. The mode depends
on your external device that connects to
this port.
Choose DMA3 (default) or DMA1.
This setting only works when the
Onboard Printer Mode is set at the ECP
mode.
Choose EPP specification Ver. 1.7 or 1.9
(default).
ÒEnter Password:Ó
ÒConfirm Password:Ó
BIOS Setup

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents