Float/Cage Assembly - Craftsman 113.177060 Owner's Manual

Float/Cage Assembly
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac with
any parts damaged or missing.
1. Remove the detachable blower from
the power head assembly by unlatching
the power head latch under the carry
handle of the detachable blower. Set
the detachable blower off to the side.
2. Unlatch the drum latch holding the lid to
tile drum. Lift the lid off the drum. Place Drum
the lid assembly of the vac upside down Latch
into the drum or place upside down on
a clean smooth surface.
3. Locate the float. Place the float over the
opening in the center of the lid with the
words "This Side Towards Lid" laying
face down over the hole.
4. Line up filter cage tabs with the slots in
the center ring of the lid assembly.
Push on the filter cage until the tabs
snap into the slots for a secure fit.
NOTE: If filter cage needs to be removed,
because the float is placed in the wrong
way, use a slotted screwdriver and
insert the blade near one of the tabs
between the filter cage and the center
ring of the lid. Pry the tab out of the slot.
Tilt the cage and lift away from the lid.
To replace, follow float/cage assembly
instructions.
End
Detachable
Lid Asm.
Power Head Latch
Cage
mn End
Slots (3)