Emptying Dust Drum; Cord Wrap; Moving The Vac - Craftsman 113.177060 Owner's Manual

Emptying Dust Drum
WARNING: To avoid injury from I
accidental starting, unplug power
I
cord before emptying the drum.
I. To remove the lid to empty contents of
the dust drum, simply liftthe drum latch
holding the lid to the drum/caddy
assembly and lift the lid assembly up
and off the drum. NOTE: Do not pick up
the lid assembly by lifting on the handle
to the detachable blower. Lift the lid
assembly by the Lid.This will ensure
that the detachable blower and the lid
will not separate during removal of the
lid assembly.
2. Lay the lid assembly upside down on a
clean dry area while emptying the drum
or changing the filter.
3. Dump the drum contents into the proper
waste disposal container.
Drum
Latch
4. If the contents Lsliquid, you may dis-
pose by using the drain provided in the
drum for easy emptying. Simply
unscrew the drain cap and tilt the drum
in a manner so the liquid flows out the
drain hole.
WARNING: avoid injury or
To back
fails, do not lift a vac heavy with liq-
uid or debris. Scoop or drain enough
contents out to make the vac light
enough to lift comfortably,
Cord Wrap
When vacuuming is complete, unplug the
cord and wrap it around the detachable
blower and upper lid assembly.
Moving the Vac
Should it become necessary to pick the
vac up to move it, the handles may be
used on the sides of the dust drum. Do
not use the handle located on the detach-
able blower to pick up the entire wet/dry
vac or the lid assembly.
Handle
\
Handle
11