Error Messages - Oki C110 Instruction Manual

Error Messages

These messages indicate errors which you must correct before a print job
can continue or the printer status return to "Ready".
Ready Attention
indicator indicator
(green) (orange)
Off Rapid
blinking
Off On
Slow Slow
blinking blinking
Slow blinking
alternately
Off Slow
blinking
Off Blinking
Toner Condition
indicator
(orange)
On Toner out
» Note:
message
appears when
the Toner Out
Stop in the
Remote Panel
Utility is set to
On.
On The toner cartridge is
not installed.
Toner empty
* Media empty
* Media size error
The size of paper
being printed on is
different from the
size of paper
specified in the
printer driver.
* Memory full
* Front cover or top
cover is open.
* The imaging
cartridge is not
installed.
88 - C110 User's Guide
Action
Replace the toner cartridge.
» Note:
This
Stop in the Remote
Panel Utility is set to
Off, printing can
continue.
However, the printing
results are not
guaranteed.
Install the all toner
cartridges.
Replace the toner cartridge.
Load media into Tray 1.
Press the Cancel key to
cancel the error.
To print on paper of the size
specified in the printer
driver, load paper of the
correct size into Tray 1, and
then try performing the print
job again.
Press the Cancel key.
If the error is not corrected,
turn off the printer. After a
few seconds, turn on the
printer.
Close the front cover and
top cover.
Install the imaging
cartridge.
If Toner Out