Blade Tilting Control And Lock Lever Adjustment; Adjusting 90 And 45 Degree Positive Stops; Adjusting Positive Stop At 90 Degrees; Adjusting Positive Stop At 45 Degrees - Sears Craftsman 113.221770 Owner's Manual

Blade Tilting Control and Lock Lever Adjustment
1. Loosen blade tilting lock lever and slide the elevation
handwheel until blade is at desired angle and tighten
blade tilt lock lever.
2. If blade lock lever interferes with some object before
blade tilting control mechanism is held tight or rigid,
pull lock lever out and rotate lock Fever counterclock-
wise to another position. Tighten lock lever. Recheck
for proper adjustment of blade tilt lock lever,
3. I1 lock lever won1 loosen enough so blade can be
tilted, pull lock lever out and rotate lever clockwise to
another position. Tighten blade lock lever,
EJevation Handwheel
Blade Tilt Lock Lever
Adjusting 90 and 45 Degree Positive Stops
Your saw is equipped with positive stops for last and
accurate positioning ol the sawblade at 90 and 45
degrees to the table. Always measure blade position
from the left side of the blade. Blade insert may not be
flush with table top.
I WARNING: To from source _vhen making I
prevent personal injury, ahvays dis- I
connect plug
power
adjustments.
!
Adjusting Positive Stop at 90 Degrees
1. Unplug the saw.
2. Turn elevation wheel clockwise and raise blade to
maximum height,
3. Loosen the blade tilt lock lever and push the elevation
wheel to the left as far as possible and tighten the
blade tilt lock lever
4. Place a combination square on the table with one end
of square against the blade as shown and checkto see
if the blade is 90 ° to the table.
5. If the blade is not 90° to the table, loosen the blade tilt
lock lever, loosen 90 ° adjustment screw (A) a few turns
and push the elevation wheel until the blade is 90 ° to
the table
6. Tighten blade tilt lock lever and tighten 90 ° adjustment
screw until it stops.
\
\
Adjusting Positive Stop at 45 Degrees
1. Loosen the blade tilt lock lever and push elevation
wheel to the right as far as possible and tighten the
blade tilt lock lever.
2. Place a combination square on the table with one end
ol the square against the table as shown, and check to
see if the blade is 45 ° to the table,
3. It the blade is not 45 ° to the table loosen the blade tilt
lock lever, loosen 45 ° adjustment screw (B) a few turns
and push the elevation wheel until the blade is 45 ° to
the table.
4. Tighten blade tilt lock lever and tighten 45 ° adjustment
screw until it stops,
° " t
90 Adiustmen Screw (A)
Blade insert
45 ° Adjustment Screw (B)
/
/
/
14