Assembly Of The Front Stop Blocks To The Dovetail Base - Sears Craftsman 171.25450 Owner's Manual

14) Assemble the othercam handle to theotherendof the pivot shaftusinga 13/64"I,D.x 9/16"O.D,washerand a#10-32 X 5/8"long
penhead machinescrew,asshownin Figure14.
15) Makesurethat thecamhandlelinesup with the camhandleat theotherend ofthe pivotshaftandthat theend ofthe camhandlefits into
the holein thebase.
16)Tightenthe screwsecurely, LEFT TEMPLATE SUPPORT
Fig. 14
/_ #10-32 X5/8"LONG
PANHEAD MACHINE
SCREW
_" DAMHANDLE
17)Rotateone of thecamhandtes-ltshoutdrotatefreelyand movethetemplatesupports,
18) If this doesnot happen, l oosenthescrewon the retainerand movetheretainerawayfrom thesidewall slightly,
19)Securely retightenthescrew.
20) If thereis too muchside-to-side movement ( play)of the cam handles; l oosenthescrewin theretainerand movetheretainerc/oserto the
sidewaltof the base.
21) Securely retightenthescrew,
ASSEMBLY OFTHEFRONTSTOPBLOCKS TOTHEDOVETAIL BASE
1) Aseemble the front stop blocks tothefront of thedovetailbase,at eachend,using#10-32x 5/8"long flatheadmachine screws,13/64_
I.D.x 9/16"O.D.washers, a nd#!0-32 hexnuts,as shownin Figure15.
2) Makesurethat theopenrib portionfits intothe slot in the front of the base. T hestop blockwglfit intothe slot in onepositiononly,
3) Tighten the screwsecurelyontothenut.
4) Assemble theotherfront stop blockto oppositeend o1the dovetag basein the samemanner.
Fig. 15
FOR REASONS OFCLARITY, THE FRONT
CLAMPING B AR, K NOBS, BOLTS AND
SPRINGS ARE NOT SHOWN
WASHER
DOVETAIL BASE \
SLOT _
#10_32XB/8OLONG
FLATHEADMACHINE
SCREW
SUPPORT
#10-32 HEX
13/64 _ LD.X9/16°O.D/
WASHER J
FRONT STOP BLOCI_
_ FRONT O F DOVETAtL BASE
5/8"LONG FLATHEAD
MACHINE SCREW
10