Tools Needed For Assembly - Craftsman 919.670040 Owner's Manual

120/240 volt 4250 watt generator
Table of Contents

Advertisement

CARTON
CONTENTS
° Parts Bag
t - Generator
1 ° Parts
Box
f
....
t - Handle
"t - TwistJock Plug LS-20P
t
= Owner's
ManuaJ
"t = Twistloek
PJug L14-20P
* _
To be installed and/or used in
accordance
with appropriate
HocaH eHectricaHcodes
and regubfions.
Refer to enclosed instructions for
proper installation.
t = isolator
Foot
7 = 5/16-t8
x 3/4 "
9 - 5/t6=t8
Cap Screws
Lock Nuts
(6 used)
2 = Washers
2 - 3/8ot6
Lock Nuts
Read owner's manual.
Do not attempt to operate equipment until you have read Owner's
Manual for Safety, Assembly, Operation, Maintenance, Storage Instructions.
NOTE: Left and right describes
the location of a part
with the operator
facing the outlet panel.
TOOLS
NEEDED
FOR ASSEMBLY
1 - Box Cutter or Knife
2 - 1/2" Wrenches
2 - 9/16" Wrenches
1 - 1" thick x 1 ' square piece of wood
REMOVE
GENERATOR
FROM
CARTON
Open carton from top.
Cut carton along dotted lines.
Remove all carton inserts.
Remove generator through opening in carton.
iMPORTANT:
Before any attempt to start your genera-
tor be sure to check engine oil (See Adding Engine Oil
paragraph in the Operation section on page 13 of this
manual.)
9 -- ENG
MGP 670040

Advertisement

Table of Contents
loading

Table of Contents