Advertisement
DRILL-DRIVER
315.114610
Maximum Torque
337 in.lb.
Chuck
3/8 in. Keyiess
CHARGER
Item No. 9 11379
Motor
DC Motor 18 Volt
(1426161 )
Gear Train
Two Speed
Rating
120 V, 60 Hz, AC only
No Load Speed
0-350/min. (Low)
Charging Voltage
18 Volt
0-1300/min (High)
Charge Rate
3-6 Hours
Clutch
24 Positions
BATTERY
PACK
Item No. 9 11378
(1323620)
KNOW YOUR
DRILL-DRIVER
See Figure 1.
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
KEYLESS
CHUCK
Your drill-driver has a keyless chuck that allows you to hand
tighten or release drill bit in the chuck jaws.
SWITCH
To turn your drill-driver ON, depress the switch trigger.
Release switch trigger to turn your drill-driver OFF.
SWITCH
LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
VARIABLE
SPEED
This toot has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
TWO SPEED
GEAR TRAIN
Your drill-driver has a two speed gear train designed for
drilling or driving at HI or LO speeds. A slide switch is
located on top of your drill to select either HI or LO speed.
FORWARD/REVERSE
SELECTOR
(DIRECTION
OF ROTATION SELECTOR)
Your drill-driver has a forward/reverse
selector located
above the switch trigger.
WRIST
STRAP
A wrist strap is provided to reduce the chances of
dropping your drill-driver. Place one hand through the wrist
strap when carrying tool.
BIT STORAGE
When not in use, bits provided with your drill-driver can be
placed in the storage area located on the bottom of the
motor housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the top and end of the motor housing.
dl_
WARNING:
If any parts are missing, do not operate
your drill-driver until the missing parts are replaced.
Failure to do so could result in possible serious
personal injury.
7
Advertisement
