Installation Of Front Table - Sears Craftsman 113.23161 Owner's Manual

k.
Move the carriage out near the end of radial arm and
move the arm until the end of motor shaft is over
the table support above the front support attaching
screw. Tap the table support upward or downward
until the arbor wrench slides with the same "'feel",
as in the previous setting of left-hand support.
After setting the forward position of table support,
move the carriage rearward to the first position
checked in order to make sure that adjusting the
forward position did not affect the rear setting. Tap
the table support upward or downward as required.
Several trial settings may be required.
Tighten the two hex-head support attaching screws
securely to retain the adjustment. Recheck to make
sure that tightening screws did not affect the
accuracy of the adjustment.
Move the radial arm over to the right-hand table
support and adjust it in the same manner. Make sure
all four table support attaching screws are tight.
TABLE SUPP©PT-
(LEFT-H AND)
FRONT SUPPORT
ATTACHING SCRE\ ^,
J
j J"
TABLE SUPPORT
RIGHT-HAND)
1
RBOR V_RENCH
n.
Loosen the bevel lock knob, pull out on bevel index
knob and rotate the motor and carriage assembly
until the swivel index knob indexes the motor with
the shaft m a horizontal (zero) position. Tighten the
bevel lock knob.
S'7,1vEL INDEX KNOB
,( _' NOB
BE.'EL L©C_ KNC _'_-"_'-'-J
2. Installation of Front Table.
a.
Place the large table board upside-down on the
floor. Distinguish between the one through-bored
(leveling screw) hole near the center of the table
board, and the seven counterbored holes. The
counterbores are in the top surface of the board.
Drive the T-nut into the through-hole. (Illustration
shows the T-nut installed.)
T-NUT
BOTTOM SIDE SF TABLE
Place the 1/4-20 U-clip nut on the base cross
member to receive the _,enter front table attaching
screw.