Table of Contents
Advertisement
SERVICE
CAUTION:
BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
,
Release control bar.
Make sure the blade and all moving parts have completely stopped.
,
Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST
CUTTING
HEIGHT
See "TO ADJUST CUTTING HEIGHT" in the Operation
section of this manual..
REAR DEFLECTOR
The rear deflector, attached between the rear wheels o!
your lawn mower, is provided to minimize the possibility
that objects will be thrown out the rear of the lawn-mower
into the operator's mowing position,.
if the rear deflector
becomes
damaged,
it should
be
replaced.
TO REiVIOVE/REPLACE
DRIVE BELT
(See Fig. 15)
°
Remove drive cover,, Remove bett by pushing down
on gear case pulley,,
.
Turn lawn mower on its side with carburetor and fuel
cap up
°
Remove blade,
o
Remove debris shield,
-
Remove belt from engine pulley on crankshaft,,
o
Install new belt by reversing above steps,,
o
Always use factory approved
belt to assure fit and
long life_
DRIVE
COVER
m
i|
IL
FIG. '15
15
Advertisement
Table of Contents
