Advertisement
Available languages
Available languages
•
Use recommended
accessories (refer to page 13).
Use of improper accessories
may cause risk of
injury to persons.
•
Handle workpiece correctly. Protect hands from pos-
sible injury.
•
Turn machine off if it jams. Belt jams when it digs too
deeply into workpiece. (Motor force keeps it stuck in
the work.)
•
Support workpiece with miter gauge, belt platen,
work stop or work table.
•
Maintain 1/16" m aximum clearance between table and
sanding belt or disc.
CAUTION:
Think safety! Safety is a combination of
operator common sense and alertness at all times
when tool is being used.
WARNING:
Do not attempt to operate tool until it is
completely assembled according to the instructions.
Refer to Figure 1.
Check for shipping damage. If damage has occurred, a
claim must be filed with the carrier for fastest action.
Parts which need to be fastened to the unit should be
located and accounted for:
A Disc Table
B Abrasive Disc
C Miter Gauge Assembly
D Horizontal Stop Bar with Nut
E 1" Belt
F Work stop
G Belt Table
H Two Knobs
Parts bag includes: one 10-1.50 x 25mm socket head
bolt, one 10mm flat washer, one 10mm lock washer,
two 6mm flat washers and one 8-1.25mm hex nut.
A
B
C
_
_
_E
Figure 1 - Unpacking
Refer to Figures 2 and 3.
CAUTION:
Do not attempt assembly if parts are miss-
ing. Use operator's manual to order replacement parts.
3
ATTACH ABRASIVE
DISC TO ALUMINUM
/
DISC
Refer to Figure 2.
•
Remove dust chute by loosening screws and bolts.
•
Remove the adhesive cover from the back of the
abrasive disc.
•
Center abrasive on aluminum disc and press to paste.
•
Make sure abrasive is pasted evenly on the aluminum
disc.
•
Replace dust chute
B
ATTACH DISC TABLE
/
Refer to Figure 2.
•
Set the disc table at right angle to the aluminum disc
and secure the table position using two knobs and
flat washers. Be sure that the gap between abrasive
disc and disc table is 1/16" o r less.
Aluminum Disc
with Abrasive
Knob
_,
Flat Washer
""
_
DLst Chute
Disc Table
Screw
Trunnion
Figure 2 - Secure Disc Table and Aluminum Disc
ATTACH BELT TABLE
Refer to Figure 3.
•
Attach belt table to left side of belt housing using the
socket head bolt, lock washer and flat washer in the
hardware bag.
•
Set the belt table at right angle to the belt.
•
Be sure that gap between belt table and belt is 1/16"
or less.
•
Tighten socket head bolt to secure belt table position.
Horizontal _"
Stop Bar
Belt Table
/
_
__,_ _
Lock Washer
_.
_r'"Flat Washer
Figure 3 - Attach Belt Table
Socket Head Bolt
Advertisement
