Table of Contents
Advertisement
6.
Bend the line at the midpoint and
insert the bend into the stot in the
center rim of the spool. Ensure line
snaps into position in the slot.
Spool _
7.
With your finger between the lines,
wrap the lines evenly and firmly
around the spool in a clockwise
direction.
8.
Position the lines in the guide
slots.
9.
tnsert the ends
of the lines through
exit holes in the sides of the cover.
10. Place
the spool in the cover,
tachment witI be spinning during most of
this procedure.
Wear your protective
equipment and observe atl safety pre-
cautions. After making adjustments, tile
trimmer head or any optional attach-
ment must not move/spin at idle speed.
The carburetor
has been carefully set
at the factory. Adjustments
may be
necessary
if you notice any of the fol-
lowing conditions:
• Engine witl not idle when the throttle is
released.
• The trimmer head or optional
attach-
ment moves/spins
at idle.
Make adjustments with the unit sup-
ported so the cutting attachment
is off
the ground and will not make contact
with any object.
Hold the unit by hand
while running and making adjustments.
Keep alt parts of your body away from
the cutting attachment
and muffler,
Idle Speed Adjustment
Allow engine to idle. Adjust speed until
engine runs without trimmer head or
optional
attachment
moving or spin-
ning (idle too fast) or stalling (idle
speed too slow).
• Turn idle speed screw clockwise
to
increase
engine speed if engine
stalls or dies.
• Turn idle speed screw counterclock-
wise to decrease
engine speed if
trimmer head or optional attachment
moves or spins at idle.
_,WARNING:
Recheck the idle
speed after each adjustment.
The
trimmer head or optional
attachment
must not move or spin at idle speed to
avoid serious injury to the operator or
others.
Spool
Idle Speed Screw
Cover
11. Make sure the lines are not caught
between
the spool and the cover.
12. Reinstall the spool and cover onto
the trimmer head. Push until cover
snaps into place.
CARBURETOR
ADJUSTMENT
_iLWARNING:
Keep others away
when makingidte
speed adjustments,
The trimmerhead
or any optional at-
Air Filter Cover
If you require further assistance
or are
unsure about performing
this proce-
dure, contact your Sears Service Cen-
ter or call our customer
assistance
help line at 1-800-235-5878.
17
Advertisement
Table of Contents
