Craftsman 900.748280 Operator's Manual page 7

G
REMOVING BLOW TUBE, VAC TUBE
OR COLLECTION BAG (FIGURE 11)
• To remove the blow tube, vac tube or
shoulder collection bag, depress the
release button on the power head and
pull straight off (figures 9 & 11).
• To turn the tool ON, rotate the knob
clockwise. The further the knob is
rotated, the higher the air speed.
• To turn tool OFF, rotate the knob
counterclockwise to the off position (0).
O
[o] :,1 :l-'r:_l / I #[_11 #F.'ll/-'tl_a.]l / [o] #F. 1
USE AS A BLOWER:
ALWAYS WEAR SAFETY GLASSES.
WEAR A FILTER MASK IF THE
OPERATION IS DUSTY. USE OF
RUBBER GLOVES AND SUBSTANTIAL
FOOTWEAR IS RECOMMENDED
WHEN WORKING OUTDOORS. FOR
HOUSEHOLD USE ONLY.
Z_WARNING: CUT HAZARD. When
turning the toot off for tube installation or
any other reason, wait 10 seconds for
the fan to stop rotating before
disassembly.
• Do not use in vacuum mode without the
vacuum tubes and collection bag in place.
• Always switch off and remove the plug
from the electrical supply when:
• Changing from blower to vacuum.
• The power supply cord has become
damaged or entangled.
• You leave btower/vac unattended.
• Clearing a blockage.
• Checking, adjusting, cleaning or
working on btower/vac.
• Use btower/vac only in daylight or good
artificial bight.
ON/OFF SWITCH (FIGURE 12)
Your blower vac is fitted with a variable
speed switch located on the top of the
power head below the handle.
CORD RETAINER (FIGURE 13)
• A cord retainer is incorporated into the
rear of the power head. It can be used in
two different ways:
• To use the cord retainer as shown in
figure 13A, hook the extension cord
under the retainer. Then plug the cord
from the power head into the extension
cord.
• To use the cord retainer as shown in
figure 13B, loop the extension cord over
the power head cord and plug the two
ends into each other. Then hook the
extension cord under the retainer.
13A 13B
BLOW MODE (FIGURE 14)
•,WARNING: Ensure product is
switched off and disconnected from the
power supply.
• Fit fan cover grill as shown in figure 1.
• Attach the blow tube assembly to the
power head as shown in figure 2.
• Connect the cord on the power head to
the power supply (figure 13).