Transmitting; Selecting The Range; Adjusting Lcd Backlighting And Display Tone; Adjusting Control Panel Brilliance - Furuno 821 Operator's Manual

2.4 Transmitting

After the power is turned on and the mag-
netron has warmed up, ST-BY (Stand-By)
appears at the screen center. This means the
radar is now fully operational. In stand-by
the radar is available for use at anytime—
but no radar waves are being transmitted.
Press the [ST-BY TX] key to transmit. When
transmitting, any echoes from targets appear
on the display. This radar displays echoes in
four tones of gray according to echo strength.
When you won't be using the radar for an
extended period but want to keep it in a state
of readiness, press the [ST-BY TX] key to
set the radar in stand-by.

2.5 Selecting the Range

The range selected automatically determines
the range ring interval, the number of range
rings, pulselength and pulse repetition rate,
for optimal detection capability in short to
long ranges.
Procedure
Press the [– RANGE +] key. The range and
range ring interval appear at the top left cor-
ner on the display.
Tips for selecting the range
• When navigating in or around crowded
harbors, select a short range to watch for
possible collision situations.
• If you select a lower range while on open
water, increase the range occasionally to
watch for vessels that may be heading
your way.
2.6 Adjusting LCD Backlighting
and Display Tone
The [BRILL] key adjusts the LCD back-
lighting in eight levels, including off. The
[TONE] key adjusts the tone (contrast) of
the display in 32 levels, including off.
Procedure
1) Press the [BRILL] key (or [TONE] key).
The display shown in Figure 2-3 appears.
BRILL
UP
TONE
DOWN
BRILL
DOWN
19
Tone
setting
<MENU TO EXIT>
Figure 2-3 Display for adjustment of
brilliance and tone
2) Press the [BRILL] key (or [TONE] key)
to set level. For fine adjustment, press
cursor pad at 12o'clock/6 o'clock for bril-
liance and 3o'clock/9o'clock for tone.
2.7 Adjusting Control Panel
Brilliance
Procedure
1) Press the [MENU] key.
2) Press the cursor pad to select Backlight/
Brilliance and press the [ENT] key.
3) Press the cursor pad to select Panel.
4) Press the cursor pad to select brilliance
level; 4 is the highest.
5) Press the [ENT] key followed by the
[MENU] key.
TONE
Item selected
UP
for adjustment
7
LCD brilliance
setting
5