Table of Contents
Advertisement
2.7.2
Internal connectors
1.
Floppy disk drive connector (34-1 pin FLOPPY1)
This connector is for the floppy disk drive (FDD) signal cable. Insert one
end of the cable to this connector, then connect the other end to the signal
connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection when
using a FDD cable with a covered Pin 5.
2.
Serial ATA connectors (7-pin SATA1–4 [red], SATA5–6 [black])
These connectors, controlled by southbridge ICH10R, are for the Serial ATA
signal cables for Serial ATA hard disk drives.
Ensure to install the ICH10R RAID driver from the support DVD during OS
installation after configuring a RAID set using the SATA connectors.
2-24
Chapter 2: Hardware information
Hide quick links:
Advertisement
Table of Contents
