4.
Serial ATA 6.0 Gb/s connectors (7-pin SATA6G 1~6)
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you
can create a RAID 0, RAID 1, RAID 5, or RAID 10 configuration through the onboard
controller.
Z77-A
Z77-A Intel
•
These connectors are set to [AHCI Mode] by default. If you intend to create a Serial
ATA RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID
Mode]. Refer to section 2.5.3 SATA Configuration for details.
•
When using NCQ, please check the SATA Mode in the BIOS is [AHCI Mode]. Refer to
2.5.3 SATA Configuration for details.
•
You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
ASUS Z77-A
SATA 6.0Gb/s connectors
®
XP Service Pack 3 or later versions before using Serial
®
XP SP3 or later versions.
®
1-29