Table of Contents
Advertisement
3.
JMicron JMB363
This connector is for a Serial ATA signal cable for an external Serial ATA hard
disk drive.
To enable hot-plugging, set the Controller Mode item in the BIOS setting
to [AHCI], and then reboot the system. See section 3.5.3 Onboard Device
Configuration for details.
4.
USB connectors (10-1 pin USB78; USB910; USB1112)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
You can connect the USB cable to ASUS Q-Connector (USB, blue) first, and
then install the Q-Connector (USB) to the USB connector onboard.
2-32
Serial ATA connector (7-pin SATA_E1 [black])
®
Chapter 2: Hardware information
Hide quick links:
Advertisement
Table of Contents
