Display Codes - CRISTAL WDC1200FWM User Manual

DISpLAY CoDES

DiSpLAY cODES AND SpEciAL FUNctiONS
CoDES CAuSES
Err1 ¬ Washer door is not properly shut .
Err2 ¬ Drainage error . Water is not emptied
within 4 minutes .
Err3 ¬ Temperature sensor error .
Err4 ¬ Heater error or laundry overload . The set
temperature is not reached within specified
time . (Appears at the end of a cycle) .
Err5 ¬ Water level not met within 8 minutes .
Err6 ¬ Dehumidification/heating error .
Err7 ¬ Motor overheat error .
Err8 ¬ Water overflow .
Err9 ¬ Error of the dryer temperature sensor .
Er10 ¬ Error of the water level sensor .
Er12 ¬ Error of the dryer water level sensor .
Er13 ¬ Dryer heater error .
Unb ¬ Laundry is unevenly distributed .
EUAr ¬ Communication error .
1:16 ¬ Status information: remaining program time is 1 hour and 16 minutes .
0:01 ¬ Status information: remaining program time is 1 minute .
60°C ¬ Status information: Wash temperature is 60°C .
-- ° C ¬ No heat (cold wash) .
0 ¬ No spin .
800 ¬ Status information: Spin speed 800 rpm .
L--1 ¬ Manually selected code when laundry weight is less than 1kg .
L--A ¬ Manually selected code when drum is nearly full .
End ¬ Program is finished .
¬ control panel lock function: Press the "Delay" and the "Start/Pause" buttons simultaneously for 3 seconds after
starting a program . It can no longer be changed by operating buttons or knobs . The washing machine emits an audible
signal while the control panel is locked . To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds .
¬ power-off memory function: In case of abrupt power failure or the need to cut off the power during a program
cycle, the present settings will be saved and the preset operation will resume when the power is on again .
¬ to cancel a program or select a new program and options during the wash cycles:
Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled . Turn the program selector again to choose another program .
MAiNtENANcE
SoLutIonS
_ Shut the door properly
_ Clean the filter and check the drain hose for blockage .
_ Please contact the Service Center .
_ Reduce load and start washing again .
_ Please contact the Service Center .
_ Check the tap and the water pressure .
_ Please contact the Service Center .
_ Please contact the Service Center .
_ Please contact the Service Center .
_ Please contact the Service Center .
_ Please contact the Service Center .
_ Check whether clothes are dry or not and whether there is
_ Please contact the Service Center .
_ Redistribute laundry to balance the drum .
_ Please contact the Service Center .
Remove filter in case any water remains in the unit .
water still in the drum . If so allow excess humidity to
escape from the appliance and try the drying cycle again .
19