Yard-Man 247.880870 Operator's Manual page 12

REPLACING THE SCRAPER
Use only original equipment manufacturer replacement
parts.
2.
WARNING: To avoid serious
personal injury,
always turn your unit off and unplug it
before you perform maintenance.
Place the unit on the ground or on a work bench.
Position the unit so the vanes and rotor are facing up.
Beneath the rotor, locate the three (3) screws securing
the scraper to the housing. Remove them using a
#T20 Torx bit or fiat blade screwdriver (Fig. 11).
3. Remove the scraper and discard it appropriately.
4. The new scraper wiii snap into place. Once in place,
attach it to the unit by reinstalling the three (3)
screws.
Torque the screws to:
25-30 inoib (2.84.3 Nora).
before you clean or service it.
Use a small brush to clean off the outside of the unit. Do
not use strong detergents. Household cleaners that
contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth.
TRANSPORTING
, Secure the unit while transporting.
To move the unit, grasp it by the top and middle front
handles (Fig. 12).
if you are transporting the unit with the handles folded,
be careful not to make contact and accidentally bend
the discharge directional control (Fig. 6). if you bend or
damage the control, you can no longer adjust the
vanes.
Scraper
Fig. 11
STORAGE
• Allow the motor to coon before storing.
• Store the unit bcked up to prevent unauthorized use
or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
Fig. 12
12