Page 1
Operator's Manu I Single Stage Snow Thrower Models 285 & 295 Models E285 &E295 IMPORTANT: Read safety rules and instructions carefully before operating equipment. Warning: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- covered, brush-covered or grass-covered...
Page 2
TABLEOFCONTENTS Content Page Important Safe Operation Practices .................. Assembling Your Snow Thrower ..................Know Your Snow Thrower ....................Operating Your Snow Thrower ..................Making Adjustments ......................Maintaining Your Snow Thrower ..................Off-Season Storage ......................Troubleshooting ........................ Parts List .......................... FINDINGMODELNUMBER This Operator's Manual is an important part of your new snow thrower.
Page 3
SECTION 1: IMPORTANT SAFEOPERATION P RACTICES WARNING: This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury.
Page 4
5. Never runanengine i ndoors orinapoorly v entilated Maintenance & Storage area. E ngine e xhaust contains carbon m onoxide, an Never tamper with safety devices. Check their proper odorless and deadly g as. operation regularly. 6. Donot o perate m achine while under theinfluence of Disengage the auger control bail and stop engine.
Page 5
SECTION 2: ASSEMBLING YOUR SNOW THROWER Unpacking FromCarton Raise the upper handle in the direction shown in Figure 1 until it clicks into the operating position. Cut along comers of the carton and lay it down flat. Make sure not to pinch or crimp the cable. Remove packing material.
Page 6
SECTION 3: KNOW YOUR SNOW THROWER WARNING: Be familiar with all the controls on the snow thrower and their proper operation. Know how to stop the machine and disengage them quickly. Recoil Starter Gasoline Cap_ Fuel Plug -_._,__ If Equipped) Access Chute Choke...
Page 7
SECTION 4: OPERATING Y OUR SNOW THROWER Before Starting The electric starter is equipped with a grounded three-wire power cord and plug, and is designed to operate on 120 volt AC household current. WARNING: Read, understand, and follow all Determine that your house wiring is a three-wire instructions and warnings on the machine and grounded system.
Page 8
ToStop Engine Position the discharge chute opening by using the Chute Handle to throw the snow in the desired To stop engine, turn ignition key counter-clockwise. direction. See Figure 5. Disconnect the spark plug wire from the spark plug to prevent accidental starting while equipment is unattended.
Page 9
SECTION 5: MAKING ADJUSTMENTS WARNING: NEVER attempt to make any adjustments while the engine is running except where specified in the operator's manual. ShavePlate To check the adjustment of the shave plate_ place the unit on a level surface. See Figure 6. The wheels, shave plate and augers should all contact level surface.
Page 10
SECTION 6: MAINTAINING YOUR SNOW THROWER Replacing S have Plate _WARNING: Before servicing, repairing, or The shave plate is attached to the bottom of the auger inspecting, disengage the auger control bail housing and is subject to wear. It should be checked and stop eng he.
Page 11
SECTION 8: TROUBLESHOOTING GUIDE Problem Cause Remedy Engine fails to start Fuel tank empty, or stale fuel FilI tank with clean fresh gasoline. Blocked fuel line Clean fuetline Key not in ON position Insert key and turn to ON position Spark plug wire disconnected Connect wire to spark plug.
Page 15
Models 285, E285, 295 & E295 REF. PART DESCRIPTION Extension Cord 629_0071 710-0157 He;<Screw, 5/16_24 x 75 710-0409 He;<Screw, 5/16_24 x 1.75 710-0654A Self Tapping Screw, 3/8_16 x 1.00 710-0751 He;< Screw, 1/4_20 x .62 710-1003 Screw, #10-16 x .625 712_0324 He;<...
Page 16
MANUFACTURER'S LIMITED WARRANTY FOR: YaRD'MaNi}// The limited warranty set forth below is given by MTD LLC with MTD does not extend any warranty for products sold or exported outside of the United States, its possessions respect to new merchandise purchased and used in the United States, its possessions and territories and territories, except those sold through MTD's authorized channels of export distribution.