Fujitsu SPARC Enterprise M4000 Installation Manual page 37

4. From the ok prompt, use the probe-scsi-all command to confirm that the
storage devices are installed.
ok probe-scsi-all
/pci@0,600000/pci@0/pci@8/pci@0/scsi@1
MPT Version 1.05, Firmware Version 1.07.00.00
Target 0
Unit 0 Disk
73 GB
SASAddress 5000c5000092beb9
Target 1
Unit 0 Disk
73 GB
SASAddress 5000c500002eeaf9
Target 3
Unit 0 Removable Read Only device
SATA device PhyNum 3
5. Use the show-devs command to confirm that the PCI devices are installed.
ok show-devs
/pci@41,700000
/pci@40,600000
/pci@48,4000
/cmp@480,0
/pseudo-mc@240,200
/nvram
/pseudo-console
/virtual-memory
/memory@m0
/aliases
/options
/openprom
/chosen
/packages
/pci@40,600000/pci@0
/pci@40,600000/pci@0/pci@9
/pci@40,600000/pci@0/pci@8
/pci@40,600000/pci@0/pci@8/pci@0,1
/pci@40,600000/pci@0/pci@8/pci@0
/pci@40,600000/pci@0/pci@8/pci@0,1/ethernet@1
/pci@40,600000/pci@0/pci@8/pci@0/network@2,1
/pci@40,600000/pci@0/pci@8/pci@0/network@2
SEAGATE ST973401LSUN72G 0556
PhyNum 0
SEAGATE ST973401LSUN72G 0556
PhyNum 1
143374738 Blocks,
143374738 Blocks,
TSSTcorpCD/DVDW TS-L532USR01
Chapter 3 Installing the Server 3-13