To Delete A Cod Key - Fujitsu SPARC Enterprise M4000 Features Manual

3. Verify that the key was added to the COD database:
XSCF> addcodactivation -r
The key you add should be listed in the output. See
Status" on page
4. Save the key in a safe place where you can refer to it if the XCP configuration
is reset, the COD database is lost, or some other event requires you to reinstall
it.
Note – Do not attempt to install the same COD key more than once, except as noted
in Step 4. Doing so would be a contract violation.

▼ To Delete a COD Key

Before deleting a key from the COD database, the XSCF firmware determines
whether a sufficient number of active COD CPUs are available, plus headroom. If all
activated COD CPUs are in use and no headroom is available, the operation fails.
You can force the operation by using the -f option in
will overcommit any COD CPU reservations that might be in effect.
1. Log in to the XSCF console with platadm privileges.
2. Verify that you have enough COD permits or headroom to cover COD resources
currently in use.
Use the showcodactivation command as described in
Status" on page
compensate, power off one or more domains or disconnect the appropriate
number of boards.
3. Delete the key from the COD database:
XSCF> deletecodactivation key
4. Verify that the key was removed from the COD database:
XSCF> deletecodactivation -r
The key that you deleted should not be listed in the output. See
Permit Status" on page
13.
13. If you do not have sufficient COD permits or headroom to
13.
"To Display COD Permit
Step 3, below, but doing so
"To Display COD Permit
Capacity on Demand (COD) Administration
"To Display COD
9