Table of Contents
Advertisement
6. Bring the thread back to the inner thread guide. Insert the thread into the hole from the upper
section into thread guide A y and lower thread guide u.
7. Pass the thread through the hole of the needle bar thread guide i and pass it through the
needle eye. Do not pass it through the presser foot. Pass it to needle bar thread guide at the
front of lower thread guide u.
BES-1216AC
wThread breakage pulley
eUpper thread
guide (upper)
rUpper thread
guide (middle)
tThread guide
(upper)
yThread
guide A
uLower thread
guide
iNeedle bar
thread
guide
1. Pass an upper thread from the cotton stand through the holes of the thread guide right above each
cotton stand bar. When passing the thread, pass it through the first hole from the lower side, lead
it around the thread guide, and then pass it through the second hole also from the lower side.
2. Push up the thread guide tension disc with your finger, and pass it from the left to the lower
hole. Wind the thread clockwise twice around thread breakage pulley w.
3. Pass the thread through the hole of upper thread guide(upper) e. Wind the thread clockwise
once around the rotary tension disc and place it on the spring.
4. Pass the thread through each hole of upper thread guide(middle) r and thread guide(upper) t.
5. After passing the thread through the hole of thread guide(upper) t, insert the thread into the
front side of the inner thread guide and pass it through the hole of the thread take-up.
6. Bring the thread back to the inner thread guide. Insert the thread into the hole from the upper
section into thread guide A and lower thread guide u.
7. Pass the thread through the hole of the needle bar thread guide i and pass it through the
needle eye. Do not pass it through the presser foot. Pass it to needle bar thread guide at the
front of lower thread guide u.
qThread guide tension disc
Spring
Inner thread
guide
uLower thread
BES-916AC • BES-1216AC
guide
Chapter 1 Preparation of Embroidery Machine
25
Advertisement
Table of Contents
