Table of Contents
Advertisement
Chapter 1 Preparation of Embroidery Machine
4. Preparation for Embroidering
Turn off the power switch before starting preparation.
Failure to do so may start the machine unintentionally through an accidental activation of the START switch,
resulting in bodily injuries.
4-1 Upper Threading
BES-916AC
qThread guide tension disc
wThread breakage pulley
eUpper thread
guide (upper)
rUpper thread
guide (middle)
tThread guide
(upper)
yThread
guide A
uLower thread
guide
iNeedle bar
thread
guide
1. Pass an upper thread from the cotton stand through the holes of the thread guide right above each
cotton stand bar. When passing the thread, pass it through the first hole from the lower side, lead
it around the thread guide, and then pass it through the second hole also from the lower side.
2. Push up the thread guide tension disc with your finger, and pass it from the left to the lower
hole. Wind the thread clockwise twice around thread breakage pulley w.
3. Pass the thread through the hole of upper thread guide(upper) e. Wind the thread clockwise
once around the rotary tension disc and place it on the spring.
4. Pass the thread through each hole of upper thread guide(middle) r and thread guide(upper) t.
5. After passing the thread through the hole of thread guide(upper) t, insert the thread into the
right side of the inner thread guide and pass it through the hole of the thread take-up.
24
Spring
Inner thread
guide
BES-916AC • BES-1216AC
CAUTION
uLower thread
guide
Advertisement
Table of Contents
