How To Change Option Content - Ford Expedition Modifiers Manual

Electrical
8. Check for acceptable crimp.
(1) Crimp should be centered on each end of the butt splice.
(2) Wire insulation does not enter butt splice.
(3) Wire is visible through inspection hole of splices.
9. Evenly position supplied heat shrink tubing over wire repair.
10. Use shielded heat gun to heat the repaired area until adhesive flows out of both ends of the
heat shrink tubing.
11. Reconnect the battery ground cable.

How To Change Option Content

Courtesy Lamp Disable (Dark Mode)
Move the panel dimmer control to the full down position, past detent, to prevent the interior lights
from illuminating when the doors are opened.
Section 2: Electrical
2010 Expedition SSV Modifiers Guide, 07/2009
2-19