Vehicle Description - Ford SUPER DUTY F SERIES Incomplete Vehicle Manual

INCOMPLETE VEHICLE MANUAL COVER
The cover of this manual identifies the incomplete vehicle
configuration for which compliance representations are
contained in this manual. Also, a label is affixed to the cover
which includes the Vehicle Identification Number (VIN) for
the specific vehicle to which this manual belongs. The label
identifies the following information which pertains only to the
vehicle with the corresponding VIN.
• The GVWR
• The front and rear GAWRs
• Tire and wheel size
• Cold tire inflation pressure (kPa/PSI)
• Completed vehicle type(s) into which the incomplete
vehicle may be manufactured
• Optional prep package when the vehicle is so equipped
INCOMPLETE VEHICLE INFORMATION LABEL
All F-Series Super Duty incomplete vehicles manufactured
by Ford Motor Company will have an Incomplete Vehicle
Information label affixed to the driver-door lock pillar. The
sample labels, shown below, are typical of that provided.
The 5th, 6th, and 7th digits of the Vehicle Identification Number
(VIN) will identify the incomplete vehicle type.These three digits
are used in the Completed Vehicle Types chart on page 7.
DATE OF
MANUFACTURE
VEHICLE TYPE
(SEE CHART
ON PAGE 7)
OPTIONAL
PREP PACKAGE
DATE OF
MANUFACTURE
VEHICLE TYPE
(SEE CHART
ON PAGE 7)
INCOMPLETE VEHICLE INFORMATION LABEL

VEHICLE DESCRIPTION

VEHICLE DESCRIPTION
INCOMPLETE VEHICLE MANUFACTURED BY
FORD MOTOR COMPANY
MADE IN U.S.A.
DATE : 01/06
GVWR:
11000LB/4989KG
FRONT GAWR:
REAR GAWR:
4200LB
WITH
3742KG
1905KG
TIRES LT215/85R16D
LT215/85R16D
16X6K
RIMS
16X6K
AT PSI COLD AT
58
VIN: 1FDKF37LO6EA53769
EQUIPPED WITH THE FORD
AMBULANCE PREP PKG.
EXTERIOR PAINT COLORS
WB TYPEGVW BODY TRANS AXLE TAPE
F379
161 AJ8 E
TYPICAL F-SERIES - U.S.
01/06
DATE
VIN: 1FDLF47P36EA47541
TYPICAL F-SERIES - CANADA
6
California Air Resources Board (CARB), requires a Vehicle
Identification Number (VIN) Label having a non-contact, bar-
code, reading wand capability. The bar-code directly below
the VIN on the Incomplete Vehicle Information label, when
provided, will comply with this regulation. See page 28 for
location and other requirements.
The Canadian Motor Vehicle Safety Act and Regulations
require installation of an Incomplete Vehicle Information label
with the National Safety mark on it on vehicles manufactured
for sale in Canada. A label representative of those installed by
Ford Motor Company assembly plants is shown below.
OPTIONAL PREP PACKAGES
Incomplete vehicles produced by Ford Motor Company, in
some instances, are equipped with an optional prep package,
such as Ambulance Prep. The completed vehicle type charts
on page 7 will identify incomplete vehicles and the optional
prep packages or trim codes that may be required by Ford
Motor Company if final stage manufacturers wish to rely on
the Statements of Conformity or, in some cases, preserve the
Ford Motor Company new vehicle warranty.
If an incomplete vehicle is equipped with an optional prep
package, both the Incomplete Vehicle Information label affixed
to the vehicle and the label on the front of this manual will
identify the prep package.
8250LB
WITH
TIRES
RIMS
PSI COLD
65
DUAL
410047
VSO
SPRINGS
65 N Y
F85B1520472AB
1019
VSO
BAR CODE V.I.N .
(CALIFORNIA)
VSO
VEHICLE
VSO
VEHICLE
F-SERIES
(March, 2005)