Model 90100
Operators Manual
2.4.6 Using the AIR DENSITY Button
Pressing the AIR DENSITY button displays the Air Density screen, see Figures 2-12 and 2-13. This
screen contains the temperature value, pressure value, and Air Density Correction Factor (ADCF). Press
the AIR DENSITY button to advance the " " cursor to the next field. To change the value or state of an
item at the " " cursor, use the UP and DOWN arrows. The 35360A TRACKER Display displays the Air
Density Correction (ADC) annunciator in the upper left-hand corner of most screens if the air density
correction is enabled, see Figure2-12.
Figure 2-12.
The Air Density Screen With Air Density Corrections Enabled
To disable the air density correction, advance the " " cursor to the ADC annunciator at the upper left of
the VFD. With the " " cursor at this position, pressing the UP and DOWN keys will toggle the air density
correction on and off.
Figure 2-13.
The Air Density Screen With Air Density Corrections Disabled
2.4.7 Using the GAIN SELECT Button (Normal Mode)
Pressing the GAIN SELECT button displays the Gain Select screen, see Figures 2-14 and 2-15. This
screen displays the five Front Panel Gain Factors (FPGF) and the Front Panel Gain annunciator "FPG".
The " " cursor points to the FPG annunciator.
Figure 2-14.
The Gain Select Screen With the Front Panel Gain Enabled
Figure 2-15.
The Gain Select Screen With the Front Panel Gain Disabled
2-10