Displaying The Current Sta For Ports - Enterasys Vertical Horizon VH-8G Management Manual

Displaying the Current STA for Ports

The parameters shown in the following figure and table are for port STA
Information.
Port
-------------------------------------------------------------------------------------------------------
1. 1000SX
2. 1000SX
3. 1000SX
4. 1000SX
5. 1000SX
6. 1000SX
7. 1000SX
8. 1000SX
Figure 2-27. Spanning Tree Port Information
Parameter
Type
Status
34 VH-8G User Interface
Vertical Horizon Local Management -- VH-8G
Spanning Tree Port Information : Port 1 - 8
Type Status
FORWARDING 4
FORWARDING 4
FORWARDING 4
FORWARDING 4
LISTENING
LEARNING
FORWARDING 4
FORWARDING 4
Use <TAB> or arrows keys to move. <Enter> to select.
Description
Shows port type as 1000SX (1000Base-SX).
Displays the current state of this port within the spanning tree:
Broken
Disabled
Blocking
Listening
Learning
Forwarding The port forwards packets, and continues learning
Designated Designated
Cost
0.0000E800E800
32768.00E029522800 128.1
32768.00E029522800 128.1
32768.00E029522800 128.5
4 32768.00E029522800 128.6
4 32768.00E029522800 128.3
32768.00E029522800 128.3
32768.00E029522800 128.3
<OK>
There is no valid link on the port.
Port has been disabled by the user or has failed
diagnostics.
Port receives STA configuration messages, but does
not forward packets.
Port will leave blocking state due to topology change,
starts transmitting configuration messages, but does
not yet forward packets.
Has transmitted configuration messages for an
interval set by the Forward Delay parameter without
receiving contradictory information. Port address
table is cleared, and the port begins learning
addresses.
addresses.
Designated
Bridge Port
128.3
VH-8G