Craftsman 917.275043 Owner's Manual page 24

TO LEVEL MOWER HOUSING
Adjust the mower while tractor is parked
on level ground or driveway. Make sure
tires are propedy inflated (See "PROD-
UCT SPECIFICATIONS" section of this
manual). If tires are over or underinflated,
you will not properly adjust your mower.
SIDE-TO-SIDE ADJUSTMENT
• Raise mower to its highest position. •
• Measure height from bottom edge of
mower to ground level at front corners
of mower. Distance "A" on both sides of •
mower should be the same.
• If adjustment is necessary, make
adjustment on one side of mower only. •
• To raise one side of mower, tighten lift
link adjustment nut on that side.
• To lower one side of mower, loosen lift
link adjustment nut on that side. •
NOTE: Each full tum of adjustment nut
will change mower height about 3/16".
Check adjustment on right side of tractor.
Measure distance "F" directly in front of
and behind the mandrel at bottom edge
of mower housing as shown.
• Before making any necessary adjust-
ments, check that both front links are
equal in length.
• If links are not equal in length, adjust
one link to same length as other link.
To lower front of mower housing,
loosen nut "G" on both front links an
equal number of turns.
When distance "F_ is 1/8" to 1/2" lower
at front than rear, tighten nut "H"
against trunnion on both front links.
To raise front of mower housing, loosen
nut "H" from trunnion on both front links.
Tighten nut "G" on both front links an
equal number of turns.
When distance "F" is 1/8" to 1/2" lower
at front than rear, tighten nut "H"
against trunnion on both front links.
• Recheck measurements after adjusting. NOTE: Each full tum of nut =G" will
Bottom Edge of Bottom Edge of change distance "F" by approximately
Mower to Ground Mower to Ground 3/8".
• Recheck side-to-side adjustment.
Mandrel
(_ Suspension
JR .,...nk
_Adjustment
_Nut
FRONT-TO-BACK ADJUSTMENT
IMPORTANT: Deck must be level side-to-
side. If the following front-to-back
adjustment is necessary, be sure to adjust
both front links equally so mower will stay
level side-to-side.
To obtain the best cutting results, the
mower housing should be adjusted so
the front is approximately 1/8" to 1/2"
lower than the rear when the mower is in
its highest position.
BOTH FRONT LINKS MUST BE EQUAL
IN LENGTH
Nut
Trunnion
Links
24