Mowing Tips - Craftsman 917.275043 Owner's Manual

8. Slowly move motion control lever f
forward, after the tractor moves A
approximately five (5) feet, slowly
l
move motion control lever to reverse
position. After the tractor moves
approximately five (5) feet retum the
motion control lever to the neutral (N) _-_.
position. Repeat this procedure with
the motion control lever three (3)
times.
Your transmission is now purged and now
ready for normal operation.
MOWING TIPS
• Mower should be properly leveled for
best mowing performance. See =TO
LEVEL MOWER HOUSING" in the
Service and Adjustments section of this
manual.
• The left hand side of mower should be
used for trimming.
• Drive so that clippings are discharged
onto the area that has already been
cut. Have the cut area to the right of the
tractor. This wilt result in a more even
distributionof clippings and more
uniform cutting.
• When mowing large areas, start by
tuming to the right so that clippingswill
discharge away from shrubs, fences,
driveways, etc. After one or two
rounds, mow in the opposite direction
making left hand turns until finished.
D
• If grass is extremely tall, it should be
mowed twice to reduce load and
possible fire hazard from dried clip-
pings. Make first cut relatively high; the
second to the desired height.
• Do not mow grass when it is wet. Wet
grass will plug mower and leave
undesirable clumps. Allow grass to dry
before mowing.
• Always operate engine at full throttle
when mowing to assure better mowing
performance and proper discharge of
material. Regulate ground speed by
selecting a low enough gear to give the
mower cutting performance as well as
the quality of cut desired.
• When operatingattachments, select a
ground speed that will suit the terrain
and give best performance of the
attachment being used.
18