Advertisement
DRILL-DRIVER
Chuck
Motor
Switch
No Load Speed
Clutch
Maximum Torque
CHARGER
Rating
Charging Voltage
Charge Rate
BATTERY
PACK
315.114500
3/8 in. Keyless
DC Motor 7.2 Volt
Two Speed
250 / 550 RPM
24 Positions
70 in.lb.
Item No. =11050
(981496-001)
120 V, 60 Hz, AC only
7.2 Volt
3-6 Hours
Item No. _11051
(1323423)
315.114510
3/8 in. Keyless
DC Motor 9.6 Volt
Variable Speed
0-600 RPM
24 Positions
90 in.lb.
Item No. 311053
(1425003)
120 V, 60 Hz, AC only
9.6 Volt
3-6 Hours
Item No. 311054
(1323424)
"Craftsman
EX 114500 - 7.2V test criteria
70
70
190
in.lb, torque
3/8 in. diameter holes per battery pack charge into 2 in. nominal pine lumber.
#8 x 1.25 in. wood screws in low speed per battery pack charge into pine lumber.
Craftsman EX 114510 - 9.6V test criteria
90
100
200
in.lb, torque
3/8 in. diameter holes per battery pack charge into 2 in. nominal pine lumber.
#8 x 1.25 in. wood screws in low speed per battery pack charge into pine lumber.
KNOW
YOUR
DRILL-DRIVER
See Figures 1 (a) and 1 (b).
Before attempting to use your drill-driver, familiarize
yourself with all operating features and safety
requirements.
KEYLESS
CHUCK
Your drill-driver has a keyless chuck that allows you to hand
tighten or release drillbit in the chuck jaws.
SWITCH
To turn your drill-driver ON, depress the switch trigger.
Release switch trigger to turn your drill-driver OFF.
SWITCH
LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
TWO SPEED
(MODEL
315.114500)
Drill model 315.114500
has a two-speed feature in the
switch. For low speed, depress switch trigger halfway. For
high speed, depress switch trigger all the way.
VARIABLE
SPEED
(MODEL
315.114510)
Drill model 315.114510
has a variable speed switch that
delivers higher speed with increased trigger pressure.
Speed is controlled by the amount of switch trigger
depression.
FORWARD/REVERSE
SELECTOR
(DIRECTION
OF ROTATION SELECTOR)
Your drill-driver has a forward/reverse
selector located
above the switch trigger.
WRIST
STRAP
See Figure 1 (b).
A wrist strap is provided to reduce the chances of dropping
your drill-driver. Place one hand through the wrist strap
when carrying tool.
BIT STORAGE
When not in use, bit(s) provided with your drill-driver can
be placed in the storage area located on the bottom of the
motor housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the back of the motor housing.
,_k
WARNING:
If any parts are missing, do not operate
your drill-driver until the missing parts are replaced.
Failure to do so could result in possible serious
personal injury.
Advertisement
