Advertisement
SWITCH
See Figure 2.
To turn your drill ON, depress the switch trigger. To turn it
OFF, release the switch trigger.
SWITCH
TRIGGER
Fig. 2
TWO SPEED
(MODEL
315.114500)
Drill model 315.114500 has a two speed feature in the
switch. Depress the switch trigger halfway for driving
screws at low speed. Depress the switch trigger all the
way for normal drilling. Release the switch trigger to turn
drill off.
VARIABLE
SPEED
(MODEL
315.114510)
This tool has a variable speed switch that delivers higher
speed and torque with increased trigger pressure. Speed is
controlled by the amount of switch trigger depression.
Note: You might hear a whistling or ringing noise from the
switch during use. Do not be concerned, this is a normal
part of the switch function.
TO INSTALL BAI-rERY
PACK
•
Lock switch trigger on your drill by placing the direction
of rotation selector in center position. See Figure 4.
•
Place battery pack in your drill. Align raised rib on
battery pack with groove inside drill. See Figure 3.
BATTERY
PACK
LATCHES
_DEPRESSLATCHESTO
RELEASEBATTERYPACK
Fig. 3
•
Make sure the latches on each side of your battery
pack snap in place and battery peck is secured in drill
before beginning operation.
,_
CAUTION:
When placing battery pack in your drill,
be sure raised rib on battery pack aligns with groove
inside drill and latches snap into place properly.
Improper assembly of battery pack can cause
damage to internal components.
TO REMOVE
BATTERY
PACK
•
Lock switch trigger on your drill by placing the direction
of rotation selector in center position.
See Figure 4.
•
Locate latches on end of battery pack and depress to
release battery pack from your drill. See Figure 3.
•
Remove battery pack from your ddll.
10
Advertisement
