Advertisement
REVERSIBLE
See Figure 3.
This tool has the feature of being reversible. The
direction of rotation is controlled by a selector located
above the switch trigger. With the drill held in normal
operating position, the direction of rotation selector
should be positioned to the left of the switch for
drilling. The drilling direction is reversed when the
selector is to the right of the switch. When the selector
is in center position, the switch trigger is locked.
,_
CAUTION:
To prevent gear damage, always
allow chuck to come to a complete stop before
changing the direction of rotation.
To stop, release switch trigger and allow the chuck to
come to a complete stop.
SELECTOR
,&
TO
WARNING:
Do not hold chuck body with one
hand and use power of the drill to tighten chuck
jaws on drill bits. Chuck body could slip in your
hand or your hand could slip and come in contact
with rotating drill bit. This could cause an
accident resulting in serious personal injury.
INSTALL
BATTERY
PACK
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
Place battery pack in your drill. Align raised rib
inside drill with groove on battery pack. See
Figure 5.
BATTERY
PACK
REVERSE
CENTERPOSITION
(LOCK)
SWITC
TRIGGER
Fig. 3
KEYLESS
CHUCK
See Figure 4.
Your drill has a keyless chuck. As the name implies,
you can hand tighten or release drill bits in the chuck
jaws. Grasp and hold the collar of the chuck with one
hand. Rotate the chuck body with your other hand.
The arrows on the chuck indicate which direction to
rotate the chuck body in order to LOCK (tighten) or
UNLOCK (release) the drill bit.
UNLOCK
CHUCK
ORILL BIT
(RELEASE)
COLLAR
LOCK
(TIGHTEN) CHUCK
BODY
LATCHES
DEPRESSLATCHES
TO RELEASE
BATTERY PACK
Fig. 5
•
Make sure the latches on each side of your
battery pack snap in place and battery pack is
secured in drill before beginning operation.
_L
CAUTION:
When placing battery pack in your
drill, be sure raised rib inside drill aligns with
groove on battery pack and latches snap in place
properly. Improper assembly of battery pack can
cause damage to internal components.
REMOVE
BATTERY
PACK
TO
•
Lock switch trigger on your drill by placing the
direction of rotation selector in center position.
See Figure 2.
•
Locate latches on end of battery pack and
depress to release battery pack from your drill.
See Figure 5.
•
Remove battery pack from your drill.
Fig. 4
8
Advertisement
