Table of Contents
Advertisement
Read and follow the assembly
and ad-
justment instructions
for your snow
thrower. All fasteners
are in the parts
bag. Do not discard any parts or materi-
al until the unit is assembled.
,_
WARNING:
Before doing
any
assembly
or maintenance
to
the snow thrower,
remove
the
wire from the spark plug.
,_
WARNING:
Always wear
safety glasses or eye
shields while assembling
snow thrower.
NOTE: In this instruction
book, left
and right describe the location of a
part from the operator's position be-
hind the unit.
Tools
Required
1
Knife
1
Pliers
1
1/2 inch open end wrenches
1
9/16 inch open end wrenches
1
3/4 inch open end wrenches
1
Measuring tape or ruler
1
Screwdriver
Figure 1 shows the snow thrower
in the
shipping position.
_./i-_
J
_
v
/
Control
_
Cable
Figure 1
Figure 2 shows the snow thrower com-
pletely assembled.
Auger
Traction Drive
"----'--"
Lever
Remote
Chute
Crank
Lever
Chute
Deflector
Height
Adjust
Skid
Figure 2
How To Remove The Snow
Thrower
From The Carton
1.
Locate all parts that are packed
separately and remove from the
carton.
NOTE: Put fuel stabilizer
in a safe
place until needed for storage.
F-O01142J
2.
Cut and discard the plastic ties that
secure the crank assembly
and the
shift rod assembly.
3.
Cut down all four corners of the car-
ton and lay the side panels flat.
4.
Cut the metal bands that hold the
snow thrower to the lower pallet.
Hide quick links:
Advertisement
Table of Contents
