Headlight Assembly - Craftsman C950-52021-0 Owner's Manual

ASSEMBLY
HEADLIGHT ASSEMBLY
The headlight is mounted on the right side of the upper
handle. It is installed upside-down for shipping purposes.
1. Remove the nut and lock washer from the carriage bolt.
2. Turn the headlight to the top side of the upper handle. En-
sure external tooth lock washer and saddle washer are
in place as shown in Figure 11.
3. Install the nut and lock washer to secure the headlight to
the handle. The headlight should point toward the snow
clearing path.
4. Attach the headlight cable with cable tie found in parts
bag to the right handle as shown in Figure 11.
External Toot
Lockwasher
Lockwasher_-_
Hex Nut
Figure 11
I
NOTE: This snow blower was shipped WITH OIL in the engine. See "Before Starting Engine" in-
structions in the Operation section of this manual before starting engine,
F_01160J 10