Headlight Assembly; Check The Tires - Craftsman c950-52913-0 Owner's Manual

HEADLIGHT ASSEMBLY

The headlight is mounted on the right side of the upper handle. It is in-
stalled upside-down for shipping purposes.
1. Remove the nut (A A , Figure 14) and lockwasher (B B ) from the carriage
bolt.
2. Turn the headlight to the top side of the upper handle. Ensure external
tooth lockwasher and saddle washer are in place as shown in Figure
14.
3. Install the nut and lockwasher to secure the headlight to the handle.
The headlight should point toward the snow clearing path.
B
A
F
Assembling the Headlight
C
D
E
Figure 14
15

CHECK THE TIRES

Check tires for damage. Check the air pressure in the tires with an accurate
gauge. See the sidewall of the tire for the proper inflation.
CAUTION: Avoid Injury! Explosive separation of tire
and rim parts is possible when they are serviced
incorrectly.
• Do not attempt to mount a tire without the proper
equipment and experience to perform the job.
• Do not inflate the tires above the recommended pressure.
• Do not weld or heat a wheel and tire assembly. Heat can
cause an increase in air pressure resulting in an
explosion. Welding can structurally weaken or deform the
wheel.
• Do not stand in front or over the tire assembly when
inflating. Use appropriate tool that allows you to stand to
one side.
NOTICE: Check side of tire for maximum tire pressure. DO
NOT exceed maximum.
ASSEMBLY