Installing Work Table - Craftsman 113.225930 Owner's Manual

6, Route the motor cord behind the motor mount,
across the top, of the base and plug it into the
receptacle in the side of the switch box.
7. Bring the power cord alongside the motor cord . . .
wrap the plastic cable hanger around the cords and
attach the hanger to the top of the base by pushing
it into a _" diameter hole.
CABLE MOTOR
_HANGER j CORD
INSTALLING WORKTABLE
NOTE: Apply coat of paste wax tothe work table,
This will make it a little easier to feed the work,
1. Loosen the table positioning screw.
2, Insert the table support rod in the hole in the base
until the edge of the table is approximately |/16"
from the abrasive disc. Tighten the screw.
NOTE: There is a second mounting hole in the base. This
is for mounting
the:
table when
the belt isused
:in a ver-
tical position.
: ;:, _ ,: : ::: i_
SECOND
MOUNTING
HOLE
TABLE
TABLE SUPPORT
POSITIONING ROD
SCREW
14