Product Overview; Operation; Controls - Exmark LAZER Z D-SERIES Operator's Manual

Operation

Product Overview

Figure 4
1. Motion control levers
2. Parking brake
3. Height of cut adjustment
4. Fuel cap (both sides)
5. Engine Controls (right
console)
6. Seat belt
7. Rollover Protection
System (ROPS)
Operation
Note: Determine the left and right sides of the
machine from the normal operating position.

Controls

Motion Control Levers
The motion control levers located on each side of
the console control the forward and reverse motion
of the machine.
Moving the levers forward or backward turns
the wheel on the same side forward or reverse
respectively. Wheel speed is proportional to the
amount the lever is moved.
Moving the levers outward from the center position
into the T-slot locks them in the neutral position
(Figure 5).
1. Neutral lock position
(handles out)
2. Neutral operate position
(handles in)
3. Front of Unit
4. Forward
Throttle Control
Located on right fuel tank.
The throttle is used to control engine speed. Moving
the throttle lever forward will increase engine speed
20
Figure 5
5. Neutral (operate)
6. Reverse
7. Neutral lock