Section V: Care And Maintenance - England's Stove Works 24-G Installation And Operation Manual

B. Draft Controls
This unit has two draft controls on the door that control the amount of combustion air
that enters the stove that in turn controls the amount of heat the unit generates. The
controls are turned in a counterclockwise direction to let in more combustion air and
produce more heat. You will have to experiment with the draft controls in order to find
the most efficient settings for your flue system, as no two flues are the same. If you have
a problem regulating this unit please contact our Customer Service department.
C. Do Not Over-Fire Your Unit
The use of flammable liquids, too much wood or burning trash in the stove may result
in an "over-fired" unit. If the chimney connector pipe or stove turns red or white, the
stove has been over-fired. In the event this happens, close the screw dampers on the
door immediately! This condition can ignite creosote in the chimney and cause a house
or chimney fire. This type fire can cause structural damage to the chimney system; do
not use the stove again until the entire system has been checked thoroughly and any
damaged parts repaired or replaced. A chimney sweep can normally perform this
inspection.
D. Every Day Fueling
This unit is designed to burn four to five hours on one good load of seasoned wood.
Prior to loading with new wood, pull the hot ashes to the front edge of the stove, and fill
the unit with seasoned wood. Allow the stove to burn freely for at least fifteen minutes
before closing the door -- once you have a good burn, close the door and adjust the
screw dampers for your desired heat level. Follow this procedure each time you add fuel
to the unit.
E. Ash Removal and Disposal
Regularly inspect the ash build-up in your stove and remove as necessary. Ashes
should be placed in a metal container with an airtight lid. The ashes should always be
placed on a non-combustible surface or on the ground, completely away from all
combustible materials. They should be retained in the metal container until all cinders
have thoroughly cooled. If you have a masonry chimney or a pre-manufactured chimney
system, it is essential to check for creosote build-up at least twice per month.

SECTION V: CARE AND MAINTENANCE

A. Gaskets
Each unit is equipped with a gasket kit around the door which should be replaced
every two years. To remove the old gasket, pull it from the channel and scrape off the
old adhesive, then place new adhesive in the channel and then the new gasket. Close
the door and allow twenty-four hours for the cement to harden prior to building a fire.
The replacement gasket for the door is part #AC-DGKC, and can be purchased from
your local dealer or ordered from the factory (phone 800-516-3636).