Delta SHOPMASTER 28-248 Instruction Manual page 12

INSTALLING THE DUST CHUTE
1. Insert the dust chute through the door opening into the slot (A) Fig. 8 in the top of the stand.
NOTE: Place the motor cord behind the dust chute unless you are using the accessory height attachment with your
saw. In that case, position the cord in front of the dust chute.
NOTE: Be certain that the tab on the dust chute (B) Fig. 9 snaps into the cutout (C) in the top of the stand.
2. Align the two slotted holes (D) Fig. 10 in the bottom of the dust chute with the two holes (E) Fig. 11 in the stand.
A
THE BAND SAW USED WITH A DUST COLLECTOR
To use this machine with a dust collector:
1. Align the four holes in the dust port (A) Fig. 12 with
the four holes in the side of the stand.
2. Insert a #10-32x1/2" pan head screw through the
two holes in the dust port (B) Fig. 12 and the stand.
Thread a #10-32 hex nut on the screw and tighten
securely.
3. Repeat this process for the two remaining holes (C)
in the dust port, stand, and dust chute.
THE BAND SAW USED WITHOUT A DUST COLLECTOR
To use this machine without a dust collector:
1. Insert a #10-32 x 1/2" pan head screw through hole
(A) Fig. 13 in the stand and dust chute. Thread a #10-
32 hex nut onto the screw, and tighten securely.
2. Repeat this process for the remaining holes in the
stand.
Fig. 8
D
Fig. 10
C
12
B
Fig. 9
E
Fig. 11
B
A
C
Fig. 12
A
Fig. 13