Craftsman 137.212520 Operator's Manual page 17

Fig. T-2
Pattern Line
Pattern Line
Laser Line
D. Aligning Parallelism (Fig. T-l, T-3 )
1. Adjust laser line parallel to pattern line by turning
screw (3) (Fig. T-1 ). NOTE: Do not overturn this
screw or it may damage internal wiring. Maximum
screw turn is 1/8 turn in each direction.
2. Move laser close to pattern line by turning
screw (4).
3. Fine tune alignment of laser is achieved by adjusting
screw (4) no more than 1/8 turn in each direction.
Fig. T-3
Laser Line Laser Line
Pattern Line