Craftsman 315.115780 Operator's Manual page 19

POSiTiVE0° BEVELSTOP
See Figure 24.
The saw has a positive 0 ° bevel stop that has been factory
adjusted to assure 0 ° angle of the saw blade when making
90 ° cuts.
TO CHECK POSiTiVE 0° BEVEL STOP
[] Remove battery pack from the trim saw.
[] Place the saw in an upside down position on a work-
bench.
[] Check the squareness of the saw blade to the base of
the saw using a carpenter's square.
TO ADJUST POSiTiVE 0° BEVEL STOP
Follow these directions to adjust the positive 0° bevel
stop:
[] Remove battery pack from the trim saw.
[] Loosen bevel adjustment knob.
[] Turn setscrew with hex key and adjust base until it is
square with the saw blade.
[] Tighten bevel adjustment knob securely.
WARNING: Attempting a bevel cut without having
the bevel adjustment knob securely tightened can
result in serious injury.
ADJUSTMENT
SCREW
HEX NUT
POSiTiVE 0°
BEVEL STOP
CARPENTER'S
SQUARE
BEVEL
ADJUSTMENT
KNOB
BLADE
Fig. 24
19