Canon ELURA 2 MC Instruction Manual page 108

¢o o
t_
O
_m
e-
"3
108
5. Press the CARD +/- buttons to select the still image to be
combined.
, Your currently recording image is combined with the pre-recorded still
image.
6. Select MIX TYPE.
, CARD CHROMA, CARD LUML, CAM. CHROMA settings appear.
7. Select tile desired setting.
8. Select MIX LEVEL.
9. Adjust tile mix level.
, Turning the SELECT dial upwards adjusts to the left and turning
downwards adjusts to the right.
10.Close the menu.
• The name of your selection flashes in the display.
IOn/Off ]
11.Press tile D.EFFECT ON/OFF button.
, The name of your selection stops flashing.
, Each time you press the ON/OFF button, your selection is activated (display
lights continuously) or deactivated (display flashes).
[ For a moving image ]
1. Press tile start/stop button to start and stop recording.
• The combined images are recorded onto the cassette.
[ For a still image ]
1. Press the PHOTO button halfway down and hold it.
• O/'lashes white in the display as the camcorder adjusts the focus and it is
displayed continuously its it green mark when the camera is ready to take the
image.
2. Press the PHOTO button fully down to record the image to the
cassette.
, O disappears from the display.
• The combined images are recorded onto the cassette for approximately 6
seconds.
[]
• You cannot use Card Mix in the Low- Light recording program (in MOVIE and
P.SCAN modes).
• If you change the position of the POWER dial or move the program selector
from [] to Q Easy Recording mode, select your still image for Citrd Mix
again.
, When setting Citrd Mix, you must cltrU out steps 1 to 5.